Better Cutting & Engraving Trails

Because of the 0.08mm compressed laser spot which is much smaller than that from LD+C-lens technology, it provides clearer & thinner cutting lines & trails as the above image shows. What’s more, since the light from LD+FAC+C-lens is collimated, the device has the same laser spot size at both fast-axis and slow-axis directions.

Laser Spot Comparision

The collimated light beam not only preserves more light sources for higher power but also presents well-balanced cutting & engraving lines from horizontal & vertical directions. This might be safely ignored when cutting circles but have a great impact beyond your imagination while cutting a rectangular design. If you have no idea, the below image would remove your confusion.